Mercury Timers (Mercury To Mercury Contacts)

IMERC State Restrictions'

Due to mercury-added products being banned or phased out in some states, MDI cannot ship Mercury added products (Relays, Switches and Floats) to the following IMERC states:
Connecticut (CT), Minnesota (MN), Maine (ME), Massachusetts (MA), New Hampshire (NH), New York (NY), Rhode Island (RI), or Vermont (VT)

These states belong to the Interstate Mercury Education and Reduction Clearinghouse (IMERC) group, which have these restrictions.

Exemptions are currently being applied for in cases where Mercury Relays and Switches are being used to replace relays and switches in equipment originally manufactured with Mercury Relays and Switches. But, currently, MDI cannot ship into these states.

Time Delay Relays
Are available with delays of up to 15 seconds on normally open units, and 4 seconds on normally closed units. The timing limitation depends on the contact action required. A time delay function is accomplished in this unit by sizing a hole in the time disc that will control the rate of the mercury flow. This controls the time it will take from the instant the coil is powered until the mercury pools make contact with each other, closing the circuit between the load terminals. Typical contact ratings 10 AMP @ 240 VAC. Pilot duty rating 720 VA. Common coil voltages are available. Standard load terminals are compression type. Coil terminals use #6 binding head screws.


SpecSheets